Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Practice Makes Better

Pages: [1]
1
Hi, for some reason when I draw a simple arc, create a pocket then generate a GCode it will not run in my  Mach 3 Mill program, it hangs up on the second arc cutting instruction and creates this error message  "radius to the end of arc differs from the radius to start"; I have Mach selected as a post processor. Will someone point me in the right direction please?

 

2
Lathes and Turning / Lathe turning using CamBam plus 1.0 and Mach 3
« on: September 26, 2022, 12:05:47 pm »
Hello, when I run my lathe code in Mach 3 the lathe cuts from left to right and at the end of the code the lathe tool advances to the center of the lathe chuck; what am I doing wrong?

Pages: [1]