1
CamBam files (*.cb) / John Deere Clock for CamBam version 0.9.8P
« on: December 06, 2015, 20:26:14 pm »
Attached is a modified version of the JOHNDEERECLOCK.cb file that will work with version 0.9.8P.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
CamBam help (General usage) / Object reference not set to an instance of an object - error.
« on: December 03, 2015, 04:37:09 am »
Please excuse my posting the same subject again. The previous posts appear to be somewhat different than my symptoms and they are several months old.
After I updated CamBam to 9.8P I discovered that I experience the above subject error on occasion. It is related to .cb files that I have downloaded from this forum. In particular the JOHNDEERECLOCK.cb file and the Nema 23 Mount v1.2.cb files. They fail consistently and never load because of the subject error.
Other .cb files on this forum consistently load just fine.
A screen shot of the failure message is attached. Not that it is needed but I am sending it anyway.
I am running Windows 7 Ultimate which is continually updated as patches are released.
16 GB RAM
Quad-core 3.4Ghz (8 processors)
Several Tbytes of rotating media
Dual 24in HD monitors.
I find that if I uninstall 9.8P and install 9.8N the problem goes away.
Upgrading 9.8N to 9.8P caused the failure to return.
You can reproduce the problem by downloading either of the above referenced files and either allowing explorer to automatically run CamBam and load the file or save the file and use Cambam to load the offending file.
Either way produces the same failure mode.
I have many files that I have created over the years with several older versions of CamBam and none of them cause CamBam to exhibit the above symptoms.
Best regards,
Jerry Ross
After I updated CamBam to 9.8P I discovered that I experience the above subject error on occasion. It is related to .cb files that I have downloaded from this forum. In particular the JOHNDEERECLOCK.cb file and the Nema 23 Mount v1.2.cb files. They fail consistently and never load because of the subject error.
Other .cb files on this forum consistently load just fine.
A screen shot of the failure message is attached. Not that it is needed but I am sending it anyway.
I am running Windows 7 Ultimate which is continually updated as patches are released.
16 GB RAM
Quad-core 3.4Ghz (8 processors)
Several Tbytes of rotating media
Dual 24in HD monitors.
I find that if I uninstall 9.8P and install 9.8N the problem goes away.
Upgrading 9.8N to 9.8P caused the failure to return.
You can reproduce the problem by downloading either of the above referenced files and either allowing explorer to automatically run CamBam and load the file or save the file and use Cambam to load the offending file.
Either way produces the same failure mode.
I have many files that I have created over the years with several older versions of CamBam and none of them cause CamBam to exhibit the above symptoms.
Best regards,
Jerry Ross
Pages: [1]