Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Attachments - pstemari

Pages: 1 [2]
Filename Downloads Message Posted
ToolRack.stl 518 Cutting notches from the side October 06, 2013, 20:17:13 pm
IMG_20130918_103021[1].jpg 1582 Re: V-Engrave Plugin September 18, 2013, 17:12:49 pm
IMG_20130918_103052[1].jpg 1495 Re: V-Engrave Plugin September 18, 2013, 17:12:49 pm
VEngraveLogoRaw.png 2565 V-Engrave Plugin August 11, 2013, 20:44:33 pm
HelloCambam.png 775 Re: Creating a new type of MOP? August 11, 2013, 20:31:51 pm
Cutviewer2.PNG 729 Re: Creating a new type of MOP? May 28, 2013, 03:38:14 am
Cutviewer3.PNG 686 Re: Creating a new type of MOP? May 28, 2013, 03:38:14 am
Toolpaths1.PNG 711 Re: Creating a new type of MOP? May 28, 2013, 03:37:19 am
Toolpaths2.PNG 718 Re: Creating a new type of MOP? May 28, 2013, 03:37:19 am
Toolpaths3.PNG 705 Re: Creating a new type of MOP? May 28, 2013, 03:37:19 am
Cutviewer1.PNG 715 Re: Creating a new type of MOP? May 28, 2013, 03:37:19 am
toolpath.PNG 739 Another status check-in April 24, 2013, 05:38:13 am
cutsurface.PNG 809 Another status check-in April 24, 2013, 05:38:13 am
VEngraveScreenShot.PNG 753 Re: Creating a new type of MOP? April 09, 2013, 14:51:51 pm
Pages: 1 [2]