I've encountered a small problem with Tabs. When I create a CB file. All is good while I'm working in the drawing. When I save it, close it, then reopen the file the holding tabs will be flipped 180 degrees. I've searched the forum and haven't found a repeat of this exact problem. I have tried a couple of fixes for other similar problems including changing tab size. I'm working on four files all similar in that they are small holes 2-3 inch diameters for speakers (tweeters) that are acting this way. Interesting is that if I change from inside to outside cuts the tabs will still flip in the wrong direction after reopening. This only happens after the file is reopened though. Also. if I only slightly touch and move the tab it will immediately flip too the correct direction. I'm uploading a file for anyone interested to look at. I'm also wondering if it isn't my original .DXF that is the problem. It's only the circles that are giving me this problem.
