Metal Nibbler 14 - Hey Lloyd

[lloydsp]

I'm not really sure I 'get' that one.  Nothing is related to spindle rotation speed.  If your 3-axis motion is accurate enough to machine those features, then it should be accurate enough to debur them, too.  Yeah, it would take some software to work out the tangents, but..

Lloyd

[lloydsp]

I'm not really sure I 'get' that one.  Nothing is related to spindle rotation speed.  If your 3-axis motion is accurate enough to machine those features, then it should be accurate enough to debur them, too.  Yeah, it would take some software to work out the tangents, but..

Lloyd

[lloydsp]

I'm not really sure I 'get' that one.  Nothing is related to spindle rotation speed.  If your 3-axis motion is accurate enough to machine those features, then it should be accurate enough to debur them, too.  Yeah, it would take some software to work out the tangents, but..

Lloyd

[lloydsp]

I'm not really sure I 'get' that one.  Nothing is related to spindle rotation speed.  If your 3-axis motion is accurate enough to machine those features, then it should be accurate enough to debur them, too.  Yeah, it would take some software to work out the tangents, but..

Lloyd

[Bob La Londe]

Well, of course, the purpose is not to actually debar those features.  The purpose is to sell that tool holder.  LOL

[Bob La Londe]

Okay that is weird.  I can't see the post I just made even if I refresh the page.  The topic list shows me as the most recent poster, but when I click on the post it doesn't show my post.  At least not to me. 

[lloydsp]

Bob,
If you look below, I posted the same thing FOUR times, because it never showed up.  I finally just gave up.  ONLY TODAY - three days later - did my posts become visible to me.  Others may have already been irritated by the repetition, but I never saw even on of them until you posted a response.  Then they all showed up.

<shrug>
Lloyd

[Bob La Londe]

Well, of course, the main purpose of that video is to sell the tool holder. 

[Bob La Londe]

I'm not really sure I 'get' that one.  Nothing is related to spindle rotation speed.  If your 3-axis motion is accurate enough to machine those features, then it should be accurate enough to debur them, too.  Yeah, it would take some software to work out the tangents, but..

Lloyd

You know, I seem to recall somebody saying profile in 3D was being worked on...  I think it was mentioned even before 1.0 became the official market release.