Struggling a bit to get this technique working.
1. In the attached file I am trying to run it on a region to create the v-engraved profile for the substrate. In a couple of places I have strange lines.
2. I seem to be missing a step to generate the correct output for CutViewer. I have all the tool settings entered but I guess the Mach3-CutViewer post processor doesn't use them. I found a reference to Mach3CVEngrave.cbpp but I don't see where that can be downloaded from.
( TOOL/MILL,3.175,0.0,0.0,0 )
Tool is a 3.175mm shank 30 deg v-cutter.
Thanks for the help!