'Relocate' MOP - move tool between MOPs avoiding clamps

[EddyCurrent]

CamBam v1.0 Release 12

After setting up two pockets with a relocate MOP between;

1. If I use, Machining->Generate toolpaths, the first vertical line is missing
2. If I use, Machining->Produce gcode, the first vertical line is shown

So it appears to be working okay here.

[jk]

First post updated with v1.1.1

* fix for a wrong default feed property (broke load/save on CB 9.

Strangely, CB1.0 wasn't affected but should :-)

[dh42]

Hello

Thank you for test. Loading error is fixed, but I can't reproduce the vertical line error.
May you supply a test file ?

I get the same result on any file (just 2 rectangles + profile mop and 2 point for the relocate mop between the 2 rectangles)

when I generate the Gcode, the first horizontal line appears but not the vertical one ... I'll do a try on win 7 to test in a moment ... (when I've read all the messages for this day and filled the heating ! (-13°C here)

++
David

[dh42]

Re

Ok, on 1.0 the pb with the first segment is only with win XP ; it works OK with Win7 . (same PC multiboot) ...

with the 0.98 (and W7) when I try to create the Gcode, I get an alert "file not found", the Gcode created is OK but the first vertical segment is missing.


oops, my fault, no pb on W7

++
David

[EddyCurrent]

New version attached for CamBam 1.0 64bit

version 1.2 (no code changes from 1.1.1, just recompiled)

[Bubba]

Thanks Eddy.