Author Topic: First attempt to do 4 axis toolpaths from a 3D model  (Read 34885 times)

Offline dh42

  • Administrator
  • CNC Jedi
  • *****
  • Posts: 7333
    • View Profile
    • Cambam V1.0 French Doc
Re: First attempt to do 4 axis toolpaths from a 3D model
« Reply #60 on: March 23, 2024, 22:04:17 pm »
Hello

Quote
It's been so long I couldn't recall for sure so I went to the CB program file, checked properties and other than Verion 1.0 I'll be darned if I can identify whether its 32 or 64 bit. How do I identify that? There was a file in the CB folder fade2D_Win32_v120_Release.dll

Go to Help/about CamBam menu

In the info panel it will be named CamBam plus [1.0] x64 if this is the 64 bits version, and only CamBam plus [1.0] if this is the 32 bits version.

Of course, the 64 bits version can only be installed on a 64 bits version of Windows ;)

++
David

Offline Tool-n-Around

  • Wookie
  • ****
  • Posts: 276
    • View Profile
Re: First attempt to do 4 axis toolpaths from a 3D model
« Reply #61 on: March 23, 2024, 22:39:24 pm »
Hello

Quote
It's been so long I couldn't recall for sure so I went to the CB program file, checked properties and other than Verion 1.0 I'll be darned if I can identify whether its 32 or 64 bit. How do I identify that? There was a file in the CB folder fade2D_Win32_v120_Release.dll

Go to Help/about CamBam menu

In the info panel it will be named CamBam plus [1.0] x64 if this is the 64 bits version, and only CamBam plus [1.0] if this is the 32 bits version.

Of course, the 64 bits version can only be installed on a 64 bits version of Windows ;)

++
David

Must be 32 bit because only says CamBam plus [1.0].

Best,
Kelly