097B

[EL34]

Using 097B Enthusiastic Enu for the first time just now

Dragging the mop's up and down the tree is putting a big smile on my face

Awesome Andy!!!!!!!!

[ajayre]

I don't see the download link. Where is it?

thanks. Andy

[10bulls]

Sorry, I haven't put up a link yet.
I was about to a week or so ago and asked a couple of people to sanity check it for me, in case there were any big boo boos in it.  It seems to be holding up quite well and I have been using it a lot myself.

However, I was concerned with the 3D machining reliability and have spent a bit more time working on that.
I have made a number of improvements which have removed the problems with 'glitches' in a number of troublesome test files.  I am currently going through my library of 3D models looking for problems but at the moment it is looking good so will most likely wrap up a new release in the next day or two.

So apologies it is taking a little longer than expected, but I'd much rather it was me to snap a cutter than you guys. 

[EL34]

I don't do any 3D stuff, so can't help you there.

I have been doing a bunch of same part - cookie cutter sheet cutouts and have not run into any problems so far.