Author Topic: Small Link Bug in the CamBam V1.0 User Documentation  (Read 141 times)

Offline pixelmaker

  • CNC Jedi
  • *****
  • Posts: 1879
    • View Profile
    • pixelmaker
Small Link Bug in the CamBam V1.0 User Documentation
« on: May 04, 2022, 19:27:18 pm »
Hello David
I found a small error in a link in the page: https://cambamcnc.com/doc/1.0/cam/creating-gcode.html
In the chapter: Creating Destination Gcode File
the link is in the line "setting called Default GCode Extension which is used to set the file extension."

The link is : https://cambamcnc.com/doc/1.0/configuration#DefaultGCodeExtension.html
it should be
https://cambamcnc.com/doc/1.0/configuration.html#DefaultGCodeExtension
The anchor is appended. Now I get a 403 - Page not found.
The problem is that the position of the anchor is loaded at the top edge of the page. It is better if the anchor is placed two table rows above.

ralf

Offline dh42

  • Administrator
  • CNC Jedi
  • *****
  • Posts: 6976
    • View Profile
    • Cambam V1.0 French Doc
Re: Small Link Bug in the CamBam V1.0 User Documentation
« Reply #1 on: May 04, 2022, 20:25:05 pm »
Hello Ralf

Ok, changes done on the master .md file, now we must wait that Andy convert the md to html ;)

++
David